Do you need to program your garage door opener so that it can work with your car’s HomeLink system? This article will come in handy for those that can’t follow their car manual in programming the garage door opener.
And for those that are making use of second-hand cars. Whatever be the case, in this piece, you will learn how to do so in less than 10 minutes following our steps carefully. If you are looking to buy a garage door opener, check the latest deals here.
You must endeavor to have the handheld transmitter, the receiver, and the in-car transmitter all in good working condition so that you can successfully program your garage door opener.
Most cars have a HomeLink system already installed. If you can’t find it in yours, you can get it from stores. It works with most garage door openers like Chamberlain, Liftmaster, Overhead Door, Genie, Craftsman, Wayne Dalton, and Allstar.
Once the garage door opener is operating on 288-433 MHZ frequency, you are good to go. To locate your unit’s frequency, check the back of your handheld transmitter.
Steps on How to Program Your Garage Door Opener
Before we move on to the steps, please note that when programming a garage door, there is a need to raise and lower the garage door. This means that you should not have children or pets around the garage while you are programming the garage door opener.
- Make sure there is a new battery inside the handheld transmitter. This is to make sure everything will work out fine without you having issues with the original battery that may no longer be working perfectly.
- The key should be turned to the accessory position where you have ACC before you start with the programming.
- If you are programming the garage door opener for the first time, or even if it has been programmed before, locate the 2 outer buttons found on the transmitter and press it for like 20 seconds. Stop when the light starts blinking.
- Still, on the transmitter, continue pressing down the button until you can see the light flashing slowly for about 20 to 30 seconds. You need to still hold it down and follow the next step.
Read Also:
- With your other hand, get the handheld transmitter and direct it towards the light that is flashing. There should be a space of about 2 inches between you and the light.
Then press down the operating button found on the handheld unit. Observe if the light will flash faster. If so, it means that you have entered the frequency to your HomeLink transmitter. You can then release the two buttons.
- For this next step, you will need someone to assist you. Other things needed are a flashlight and a ladder. Then press the training or learn or smart button located on the garage door opener receiver.
If you can’t find the button labeled any of these, you will find the button with a small light that flashes when you press it. Once the indicator light is able to light up continuously, it means that the garage door opener is now functioning.
But if the light flashed briefly before it stayed on, you only have 30 seconds to do the next step. So, have your helper close by.
- Remember that the key was turned to ACC when we started this process? Leave it in that position and then press on the button that you programmed before which is on the in-car transmitter.
Press it for 3 seconds, release your finger, and press for another 3 seconds. Do this again if the garage door opener fails to move. The programming is successful when it moves.
If you are still having challenges programming the garage door opener, unplug the receiver, wait for about 1 minute before trying again.
As long as the battery is inserted correctly and functioning properly in the handheld transmitter, the programming should work.
There are some troubleshooting fixes you can follow. But if everything else fails, you can get hold of a HomeLink customer care department or replace the garage door opener.
